Masternodes INTER ZONE setup Guide

 


Requirements :

– You need static IP with port 11994 opened for masternodes

STEP 1 : Preparing your masternodes wallet

1 – Open main wallet
2 – Click file tab / reception address
3 – Click the button “New address” and put “MN1” in Label
4 – Send to this address exactly 5000 coins (Including fees)
5 – Wait until it reach 15 confirmation then  go to the Debug console
6 – Run command, type “masternode genkey” and write down generated key (this is your masternode private key)

STEP 2 : open the .conf file and complete this:
It have format:
Code:
rpcuser=here you enter any word with several alphanumeric characters
rpcpasswordhere you enter any word with several alphanumeric characters
listen=1
port=11994
masternode=1
masternodeprivkey=here you enter your masternode genkey

Save file

#################################################################################################################################################

STEP 3 : Starting masternodes

– Close and restart your wallet
– Go to Debug console and enter the command: MASTERNODE START

 

Your masternodes should enabled now

Categories: Tutorial

2 Comments

Bo Cotton · October 18, 2017 at 11:15

Please help I entered.
It have format:
Code:
rpcuser=here you enter any word with several alphanumeric characters
rpcpasswordhere you enter any word with several alphanumeric characters
listen=1
port=11994
masternode=1
masternodeprivkey= along with my key and now I cannot open wallet.
it tells me Error: Cannot Parse config file contains a invalid line. ‘It have format:’. Only use key=value syntax. How do I fix? Thank you!

cryptalt · November 19, 2017 at 03:44

Great guide. Very helpful. Seems this coin doesn’t technically require a static IP address for masternode since you don’t configure the external ip anywhere.

Leave a Reply

Your email address will not be published.

*